Editing the TEX file

Near the beginning of your TEX file (in addition to the line \input{psfig}, insert the command

\special{header=lprep68.pro}

This file is a properly edited version of the Apple LaserPrep file that is sent to the printer by the Macintosh.

Note that the version number (68 in this case) must be the same as the version of the LaserPrep file that the PostScript file was created with. Look at the PostScript file and find the line that says `(AppleDict md)'. The number after this is the version of the LaserPrep file. If this number is 71, you would have to use the file `lprep71.pro' instead.

Now where you want the figure to be included, insert the command

\psfig{figure=filename ,bbllx=#in,bblly=#in,bburx=#in,bbury=#in}

where the number (#) you insert after bbllx is the left side of the Bounding Box, bblly is the bottom, bburx is the right side, and bbury is the top. This example shows the box dimensions in inches (in).